Arduino Uno R3 Microcontroller A000066
- Category:Personal Computer
- List Price:
- Buy New: $21.99
as of 8/20/2018 23:22 MST details
- You Save: $7.96 (27%)
- Seller:RobotShop Inc.
- Platform:Windows 8.1
- Media:Personal Computers
- Number Of Items:1
- Aspect Ratio:Unknown
- Shipping Weight (lbs):0
- Dimensions (in):3.2 x 2.2 x 1
- Legal Disclaimer:Must be at least 18 & over to purchase.
- Warranty:12 Month
Availability:Usually ships in 24 hours
- Microcontroller board based on the ATmega328 (datasheet)
- 14 digital input/output pins
- 16 MHz crystal oscillator
- USB connection
- Made In Italy
This is a genuine new Arduino Uno R3. The Arduino Uno is a microcontroller board based on the ATmega328. It has 14 digital input/output pins (of which 6 can be used as PWM outputs), 6 analog inputs, a 16 MHz crystal oscillator, a USB connection, a power jack, an ICSP header, and a reset button. It contains everything needed to support the microcontroller; simply connect it to a computer with a USB cable or power it with an AC-to-DC adapter or battery to get started. Note From Arduino Founder Massimo Banzi We stress the fact that [genuine Ardunio board from mp3Car.com] are made in Italy because in this globalized world, were getting the lowest possible price for products sometimes translates into poor pay and working conditions for the people who make them, at least you know that who made your board was reasonably paid and worked in a safe environment. (This obviously applies only to the boards marked "made in Italy", we cannot attest to the manufacturing process of "third party" boards). The Uno differs from all preceding boards in that it does not use the FTDI USB-to-serial driver chip. Instead, it features the Atmega16U2 (Atmega8U2 up to version R2) programmed as a USB-to-serial converter. Revision 2 of the Uno board has a resistor pulling the 8U2 HWB line to ground, making it easier to put into DFU mode. Revision 3 of the board has the following new features: 1.0 pinout: added SDA and SCL pins that are near to the AREF pin and two other new pins placed near to the RESET pin, the IOREF that allow the shields to adapt to the voltage provided from the board. In future, shields will be compatible both with the board that use the AVR, which operate with 5V and with the Arduino Due that operate with 3.3V. The second one is a not connected pin that is reserved for future purposes. This is the org version of this product, not the CC.
CERTAIN CONTENT THAT APPEARS ON THIS SITE COMES FROM AMAZON SERVICES LLC. THIS CONTENT IS PROVIDED ‘AS IS’ AND IS SUBJECT TO CHANGE OR REMOVAL AT ANY TIME.
Net Electronics LLC
Visit these other Specialty Shops:
As Seen On TV,Best Photo Video,Net Electronics,Plasma TV Pros